![]() We need to solder some wires to these holes in order to permit communication between the controller’s board and the Arduino MINI board. psx_controller_internals psx_controller_bigmotor psx_controller_smallmotor Soldering communication and power wires Desolder the main connector CN1 (the termination of controller’s cable on the circuit) and clean each hole. Remove both motors (we need some space) cutting each black and red wire and also detach the board unlocking the green flat cable and removing the screw. ![]() The board is connected with controller’s buttons via a flat cable (the green one with a white connector in the image below) and attached to the controller’s body with a single screw. Inside are visible the controller’s board and two vibration motor’s. psx_controller_internals_explained Dismounting the controller After removing all screws, the bottom part is detachable with ease. ![]() In this article we use an Arduino MINI board wired with the Playstation’s controller circuit, an nRF24L01+ module and a small LiPo cell with an USB charger circuit based on Microchip’s MCP73831 ic. Playstation controller hack with Arduino MINI and nRF24L01 Posted on Share: FACEBOOK TWITTER LINKEDIN PINTEREST This time we see a Playstation controller hack to use it wirelessly in our projects. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |